Westinghouse GHP17S Instrukcja Użytkownika

GHP16S, GHP16W, GHP17S,GHP17W, GHP765S, GHP775S, GHP95S, GHP95W, GHP795S

.This appliance is supplied for use with Natural Gas. However, it can be converted for use with LPG. Refer to LP

1. Check the manometer zero point is correct.2. Connect the manometer to the cooktop pressure point. This is located on the

CAUTIONThis appliance is fitted with Natural Gas burner injectors.Please follow the procedure below if a conversion to suit LP gas is required.The con

Hex nut assembly, fully screwed downInsert oriented for natural gas operationHex nut assembly, removed from regulator and insert disassembledInsert

After installation, test the appliance and ensure that it operates correctly before handing it over to the customer. The fo

Important NoticeBefore Calling a Service Technician please check carefully the operating instructions, service booklet and the warranty terms and co

AUSTRALIAphone: 1300 363 640fax: 1800 350 067email: [email protected]: www.westinghouse.com.auNEW ZEALANDphone: 09 573 2384fax:

Congratulations and thank you for choosing our Product. We are sure you will find your new cooktop a pleasure to use and a great asset to your cooking.

Please read the user manual carefully and store in a handy place for later reference. The symbols you will see in this booklet have these meanings:W

NOTE: You must read these warnings carefully before installing or using the cooktop. If you need assistance, contact your Customer Care De

All common pots and pans: aluminium, stainless steel, cast iron, ceramic, etc., may be used on your new gas model cooktop. Ensure that

  Burner will not light even though the sparker is working• Knob not held down long enough in ‘High’ posit

480mm560mm*Gas supply connection location830mmGas supply connection location*480mmFigure 4–60cm and 75cm models cut-outFigure 4–90cm models cut-out

1. The bench cutout should be made as per cutout dimensions in Figure 4.2. Adjacent walls, cupboards and protection for combustible mate

Figure 6–60cm modelsFigure 6–75cm modelsFigure 6–90cm modelsFigure 7Figure 8–60cm and 75cm modelsFigure 8–90cm models11mm86mm 86mm26mm 26mm11mm10mm10